Crumb
c/3dprinting · by chrischryse@lemmy.world · 2y

Prusa MK4 failing X-axis test

I ran a selftest and the manual test and the X-axis keeps failing. I don't know why.

I tried:

Re-lubing

adjusting the X-axis belt

Adjusting the cables

I've had no luck with anything :/

Edit: I've watched a video and the extruder just hangs on the left side it for most the time it doesn't go left then right, right aaway

Edit 2: I found the issue that I completely overlooked cuz I was annoyed...the bearing was sticking out somehow

4 points · 7 comments · view on lemmy.world

7 Comments

dirtdigger@lemmy.world · 4 pts · 2y (1 reply)

Prusa machines come with phenomenal support, why not consult them directly?

chrischryse@lemmy.world · 2 pts · 2y

Figured I'd make a post while I wait the 30 minutes

familytechie@frontrange.co · 1 pts · 2y (5 replies)
[ removed ]
chrischryse@lemmy.world · 1 pts · 2y (4 replies)

Yup. And not sure if it matters either but x axis reads as 251

familytechie@frontrange.co · 1 pts · 2y (3 replies)
[ removed ]
chrischryse@lemmy.world · 1 pts · 2y (2 replies)

I'm dumb, I found the issue...One of the bearings was sticking out Idk how I missed that especially looking stuff up ;-;

familytechie@frontrange.co · 1 pts · 2y (1 reply)
[ removed ]
chrischryse@lemmy.world · 1 pts · 2y

Np lol. I honestly didn't expect it, like it's screwed down so how could it move? I love troubleshooting soooooo much

Thanks4Nothing@lemm.ee · 1 pts · 2y (1 reply)

Was it a kit? Had it been printing before you started getting this issue or was this an issue out of the box?

chrischryse@lemmy.world · 1 pts · 2y

Yep.