Hm, I have an issue my the Solar node. It heats up too much in the sun. The panel getting hot might be one thing but the inside of the box where the batteries are? That worries me.
I installed a BME280 so it sits inside the box and the temperature reading is actually quite helpful here. I pulled the plug when it got to 55C within hours.
Has anybody experienced that? Isn’t that a problem for the batteries? I don’t need this exploding!!
12 Comments
FapFlop@lemmy.world · 4 pts · 102d
55C isn’t hot for electronics. I would be worried at 90C.
bowreality@lemmy.ca · 1 pts · 102d
Good to know but it was just a couple of hours in the sun.
fratermus@piefed.social · 2 pts · 102d
My solar node sits under a projection where it gets sun in the morning but shade afterward.
bowreality@lemmy.ca · 1 pts · 102d
Ah good idea. I had it full on south so maybe I try east of the house. See if it gets enough to charge and then shade. Thanks
spitfire@lemmy.world · 1 pts · 101d
Will that be enough during winter?
fratermus@piefed.social · 1 pts · 100d
It was this past winter, but I'm at a pretty low latitude (~31.8°). The SenseCap Solar P1 has a huge 5w panel. I run a Meshcore repeater, also NRF52-based, under the same eaves with only a 1w panel. It stayed up all winter, too.
spitfire@lemmy.world · 2 pts · 100d
Yeah, that’s much closer to the equator than I am. While this would work for me in the summer it may not in the winter - when temperatures drop well below 0 degrees Celsius (making charging less effective) , and the sun does not shine for that long (shortening the charging time significantly).
fratermus@piefed.social · 1 pts · 99d
Paradoxically, solar panels perform better in the cold , at least on MPPT controllers. It won't make a practical difference in your scenario but it's interesting. At least to geeks like me.
spitfire@lemmy.world · 1 pts · 99d
But I believe you shouldn’t charge batteries in very cold conditions (below -10C?)
fratermus@piefed.social · 2 pts · 98d
Yeah, both Li-NMC and LiFePO4 can be damaged by charging when cell temps are below freezing. There is some anecdotal evidence that the very low C (current) rates we see with small panels could make it a non-issue. One of my nodes was up over last winter and froze a few times. I haven't observed any capacity reduction although TBF I didn't do any actual capacity tests.
In my campervan where I have a 380Ah LFP bank I use warming pads to keep the cells at human-comfortable temps.
deafboy@lemmy.world · 2 pts · 100d
Mine shows 44°C using the integrated sensor (27.7°C ambient) at the moment running Meshcore. It's on the roof, so exposed to direct sun all day.
bowreality@lemmy.ca · 1 pts · 100d
Hm. I was wondering if mine had a defect. Not sure how to find out if it does though.