No worries! There is actually a controversy around the singer. The vocals might not be him but a French guy. It's been a while since I looked into it. Hope you enjoyed this belgian trivia on a French holiday!
sudo networkctl status gives you a general overview of all your network settings but indeed, it doesn't show the files used. You can do sudo networkctl to see a list of all your network devices and whether they are managed by systemd-networkd or not. For example, the 3rd device is the one I'm using to connect to the internet. The 7th device is a VPN I'm using.
➜ ~ sudo networkctl
IDX LINK TYPE OPERATIONAL SETUP
1 lo loopback carrier configured
2 enp0s31f6 ether off configuring
3 enxc84bd63372d4 ether routable configured
4 br0 bridge no-carrier configuring
5 wlp0s20f3 wlan off configuring
6 virbr0 bridge no-carrier unmanaged
7 tun0 none routable configured
7 links listed.
Just using status gives you the overview of all your IP addresses and DNS settings.
➜ ~ sudo networkctl status
● State: routable
Online state: partial
Address: 10.161.10.39 on enxc84bd63372d4
192.168.122.1 on virbr0
172.28.241.21 on tun0
fe80::ca4b:d6ff:fe33:72d4 on enxc84bd63372d4
Gateway: 10.161.10.254 on enxc84bd63372d4
DNS: 172.16.1.132
172.23.12.100
172.23.13.100
Search Domains: <REDACTED>.tld
<REDACTED>.domain.tld
Apr 08 09:45:31 debian systemd-networkd[1083]: enp0s31f6: Link DOWN
Apr 08 09:45:48 debian systemd-networkd[1083]: wlp0s20f3: Link DOWN
What you probably want is the following sudo networkctl status $INTERFACE. Here you see the Link file and Network file used by the interface.
➜ ~ sudo networkctl status enxc84bd63372d4
● 3: enxc84bd63372d4
Link File: /usr/lib/systemd/network/73-usb-net-by-mac.link
Network File: /etc/systemd/network/05-dock.network
State: routable (configured)
Online state: online
Type: ether
Path: pci-0000:05:00.0-usb-0:2.4:1.0
Driver: r8152
Vendor: Realtek Semiconductor Corp.
Model: RTL8153 Gigabit Ethernet Adapter
Hardware Address: c8:4b:d6:33:72:d4 (Dell Inc.)
MTU: 1500 (min: 68, max: 9194)
QDisc: fq_codel
IPv6 Address Generation Mode: eui64
Number of Queues (Tx/Rx): 1/1
Auto negotiation: yes
Speed: 1Gbps
Duplex: full
Port: mii
Address: 10.161.10.39 (DHCP4 via 172.27.129.1)
fe80::ca4b:d6ff:fe33:72d4
Gateway: 10.161.10.254
DNS: 172.23.12.100
172.23.13.100
Activation Policy: up
Required For Online: yes
DHCP4 Client ID: IAID:0xf40aaca/DUID
DHCP6 Client DUID: DUID-EN/Vendor:0000ab113b3d3a1477342315
Connected To: <REDACTED>.tld on port Gi2/0/19 (== USERS + VoIP ==)
Apr 08 08:55:17 debian systemd-networkd[1083]: enxc84bd63372d4: Configuring with /etc/systemd/network/05-dock.network.
Apr 08 08:55:17 debian systemd-networkd[1083]: enxc84bd63372d4: Link UP
Apr 08 08:55:17 debian systemd-networkd[1083]: enxc84bd63372d4: Gained carrier
Apr 08 08:55:18 debian systemd-networkd[1083]: enxc84bd63372d4: DHCPv4 address 10.161.10.39/24, gateway 10.161.10.254 acquired from 172.27.129.1
Apr 08 08:55:19 debian systemd-networkd[1083]: enxc84bd63372d4: Gained IPv6LL
You probably have the same .link files as me because they are the default ones. The .network files I use are custom though, for example:
I assume you're using systemd-networkd so did you try using networkctl to reload and reconfigure your networks? By using status you can see which files are being used by your interface. I hope this points you to an explanation.
➜ ~ sudo networkctl
delete -- Delete virtual netdevs
down -- Bring devices down
forcerenew -- Trigger DHCP reconfiguration of all connected clients
label -- Show address labels
list -- List existing links
lldp -- Show Link Layer Discovery Protocol status
reconfigure -- Reconfigure interfaces
reload -- Reload .network and .netdev files
renew -- Renew dynamic configurations
status -- Show information about the specified links
up -- Bring devices up
Sorry, can't help you there as I haven't tried that one. I've heard good things about it and had a look online. Now if you want my two cents, I would go with the tiny might 2. I've owned quite a few vapes and while most are good, they do tend to fail over time, especially the plastic bits and pieces. The tiny might 2 is dead simple in it's construction and assembly which gives me a lot of confidence. You can find a teardown, on youtube I think, which will illustrate just how simple it is. My first vape ever was the original 'walkie-talkie' davinci vape and if people ask for recommendations I would say either a vapcap or a tinymight. I hope this helps you a bit.
I don't have experience with that kit in particular but I did a coopers ipa a few years ago when I was brewing a lot from liquid malt extract. It kit is also LME then it's quite normal for the brews to come out quite dark. That was at least my experience when brewing from a can. I never was able to brew light, as in color, beers until I went all grain. The beers always where tasty though, albeit maybe a tad sweet. Hope this helps a bit.
Why not make edibles out of it? It hits differently but never disappoints in my opinion. I mostly make green dragon out of decarbed cannabis, with oil, pg or alcohol. 30g in 300ml gives me a good potency. Your milage may vary but it could be worth a try.
Safe as in encrypted and/or authenticated? Not at all! I only do this on networks I fully trust and with files that are not too sensitive. But it's quick and easy to set up. All my machines have python installed so hence the idea.
Honestly, I was the same. I tried to run it multiple times but the results where never good enough to make the switch. Just wanted to point out it's existence to OP.
I often spin up a quick python http server. Just go to the folder which has the files you want to transfer and run the following command: python3 -m http.server. This will server the folder content Serving HTTP on 0.0.0.0 port 8000 (http://0.0.0.0:8000/) .... On your phone you can then browse to http://PC_IP:8000 and download what you want/need.
No worries! There is actually a controversy around the singer. The vocals might not be him but a French guy. It's been a while since I looked into it. Hope you enjoyed this belgian trivia on a French holiday!
Not sure why you would recommend a Belgian musician for a French holiday but all good!
sudo networkctl statusgives you a general overview of all your network settings but indeed, it doesn't show the files used. You can dosudo networkctlto see a list of all your network devices and whether they are managed bysystemd-networkdor not. For example, the 3rd device is the one I'm using to connect to the internet. The 7th device is a VPN I'm using.Just using
statusgives you the overview of all your IP addresses and DNS settings.What you probably want is the following
sudo networkctl status $INTERFACE. Here you see the Link file and Network file used by the interface.You probably have the same
.linkfiles as me because they are the default ones. The.networkfiles I use are custom though, for example:I hope this helps you a bit.
I assume you're using
systemd-networkdso did you try usingnetworkctlto reload and reconfigure your networks? By usingstatusyou can see which files are being used by your interface. I hope this points you to an explanation.Sorry, can't help you there as I haven't tried that one. I've heard good things about it and had a look online. Now if you want my two cents, I would go with the tiny might 2. I've owned quite a few vapes and while most are good, they do tend to fail over time, especially the plastic bits and pieces. The tiny might 2 is dead simple in it's construction and assembly which gives me a lot of confidence. You can find a teardown, on youtube I think, which will illustrate just how simple it is. My first vape ever was the original 'walkie-talkie' davinci vape and if people ask for recommendations I would say either a vapcap or a tinymight. I hope this helps you a bit.
I don't have experience with that kit in particular but I did a coopers ipa a few years ago when I was brewing a lot from liquid malt extract. It kit is also LME then it's quite normal for the brews to come out quite dark. That was at least my experience when brewing from a can. I never was able to brew light, as in color, beers until I went all grain. The beers always where tasty though, albeit maybe a tad sweet. Hope this helps a bit.
Why not make edibles out of it? It hits differently but never disappoints in my opinion. I mostly make green dragon out of decarbed cannabis, with oil, pg or alcohol. 30g in 300ml gives me a good potency. Your milage may vary but it could be worth a try.
Excellent, thanks a lot! I'm very interested in the infusion aspect of the brew. I'll probably try something similar during my next brew.
Care to share the recipe? Thanks!
You might like this website: https://www.ambient-mixer.com/
Cheers!
!piracy@lemmy.dbzer0.com seems pretty active to me.Sorry, misread privacy for piracy. I'll show myself out.
Sorry I missed your reply but hope you had a blast!
Safe as in encrypted and/or authenticated? Not at all! I only do this on networks I fully trust and with files that are not too sensitive. But it's quick and easy to set up. All my machines have python installed so hence the idea.
It's a bit unclear to me what you're ready for but if you feel ready I would say go and have fun!
Greetings fellow Belgian vaporent! Like @Uranium_Green@sh.itjust.works said, it's a bit slow but definitely check out the !trees@lemmy.world group out.
I'll have a look at your blog. Thanks for the link, it pretty much illustrates my feelings towards yacy as well.
Honestly, I was the same. I tried to run it multiple times but the results where never good enough to make the switch. Just wanted to point out it's existence to OP.
I often spin up a quick python http server. Just go to the folder which has the files you want to transfer and run the following command:
python3 -m http.server. This will server the folder contentServing HTTP on 0.0.0.0 port 8000 (http://0.0.0.0:8000/) .... On your phone you can then browse to http://PC_IP:8000 and download what you want/need.Did you ever stumble upon yacy? https://github.com/yacy The website seems down but the general direction of the project might be up your alley.