Worst part, this is the one component Prusa injection molded with no parts 3D Printable. I'll probably figure something out.
Well this stinks
Worst part, this is the one component Prusa injection molded with no parts 3D Printable. I'll probably figure something out.
8 Comments
Kolanaki@pawb.social · 13 pts · 224d
Just print a ne- Oh... Yeah.
Seriously tho: Can't engineer your own? How complicated is the broken plastic part?
the16bitgamer@programming.dev · 13 pts · 224d
There are some community prints like this. https://www.printables.com/model/194982-prusa-minimini-no-logo-frontrear-plate-with-honeyc
But I don't know how brave I feel about taking it apart again.
Willem@kutsuya.dev · 10 pts · 224d
Send them a message? They are usually very helpful, you might be able to either get a model or a replacement part.
RealisticBroccoli@piefed.social · 5 pts · 224d
is it Abs? if so you could try welding it with acetone.
the16bitgamer@programming.dev · 2 pts · 223d
Just tried it, worked to hold it in position for a bit. Fell apart once I started to use it mechanically.
yaroto98@lemmy.world · 3 pts · 224d
Superglue?
the16bitgamer@programming.dev · 2 pts · 224d
The plastic is brittle. I think I'll just delay the inevitable if I use super glue
DudeImMacGyver@kbin.earth · 2 pts · 224d
Contact them